03
'15
Written on
REDEX
31
'15
Written on
NSK
NSK bearings save €11,500 a year in MRO activities
The replacement of ball bearings is part of typical maintenance schedules when it comes to electric motors. However, when a German MRO (maintenance, repair and overhaul) provider was tasked recently with performing regular overhauls of electric drives for a prominent customer, a frequently recurring problem was noted: newly installed standard bearings would fail after three or four months.
31
'15
Written on
Aavid Thermalloy
New! HDDC: a High Density Die Casting process for high thermal performance aluminium heat sinks and liquid cold plates from Aavid Thermalloy
Thermal management applications such as heat sinks, electronics enclosures, leak tight liquid cold plates etc. require characteristics such as high thermal conductivity, low porosity, leak tightness, and the ability to fabricate thin walls and tall fins.
27
'15
Written on
NSK
NSK products make debut at Agritechnica 2015
Visitors to Agritechnica 2015 (Hanover, 10-14 November) will witness the debut appearance of NSK rolling bearings designed purposely for the agriculture industry. Central to the NSK exhibit will be ‘Agri Disc Hubs’ – ready-to-install units deployed in soil tillage machinery such as compact disc harrows, seed drills and strip-till equipment.
27
'15
Written on
Morgan Advanced Materials
THROUGH THICK AND THIN – A GUIDE TO THICK AND THIN FILM COATING OF CERAMICS
Oliver Ridd of Morgan Advanced Materials discusses coating technologies, their applications and performance benefits
25
'15
Written on
EPLAN
Eplan Harness proD 2.5
Version 2.5 of Eplan Harness proD is in the start blocks. In combination with Eplan Platform's central parts management system, users benefit from continuous and optimised workflows. A wide range of enhancements for nail board design, cable routing and project management guarantee effective wire harness engineering.
21
'15
Written on
IMI
Largest ever contract for IMI Critical Engineering
3,500 valves being supplied to Gorgon gas project
21
'15
Written on
Keyence America
KEYENCE to Release Next-Generation Coordinate Measuring Machine
KEYENCE will release the XM Series handheld probe coordinate measuring machine on September 1st, 2015.
21
'15
Written on
Softing Automotive Electronics GmbH
Diagnostic Tool Set 8: Complete solution for vehicle diagnostics with lots of new functions and extensions
In the new Release 10 of Softing's Diagnostic Tool Set, alongside an increase in performance and the extended simulation engine, among other things, the focus is very much on heavy-duty diesel vehicles, the coding of ECU variants as well as Diagnostics over IP. Evaluation packages are available for DoIP and J1939.
20
'15
Written on
NSK
